N600 Wireless Dual Band Gigabit Router WNDR3700v4
The following table describes the LEDs, icons, and buttons on the front panel from left to
right.
Icon
Description
Power
•
Solid amber. The unit is starting up after being powered on.
•
Solid green. The router is ready to use
•
Off. Power is not supplied to the router.
•
Blinking green. The firmware is corrupted. Visit www.netgear.com/support.
•
Blinking amber. The firmware is upgrading, or the Restore Factory Settings button
was pressed.
Internet
•
Solid green. An IP address has been received; the routerready to transmit data.
•
Solid amber. The Ethernet cable connection to the modem has been detected.
•
Off. No Ethernet cable is connected to the modem.
2.4 GHz
•
Solid green. The 2.4-GHz wireless radio is operating.
•
Off. The 2.4-GHz wireless radio is off.
5 GHz
•
Solid blue. The 5-GHz wireless radio is operating.
•
Off. The 5-GHz wireless radio is off.
LAN
•
Solid green. The LAN port has detected a 1 Gbps link with an attached device.
•
Solid amber. The LAN port has detected a 10/100 Mbps link with an attached
device.
•
Off. No link is detected on this port.
USB
•
Solid green. The router has accepted the USB device.
•
Blinking green. The USB device is in use.
•
Off. No USB device is connected, or the Safely Remove USB Drive button has been
clicked and it is now safe to remove the attached USB device.
Wireless
•
Pressing this button for over one second turns on and off the wireless radios.
button
•
On. The 2.4-GHz and 5-GHz wireless radios are on.
•
Off. The 2.4-GHz and 5-GHz wireless radios are off, and the 2.4 GHz and 5 GHz
LEDs are off.
WPS button
Pressing this button allows you to use Wi-Fi Protected Setup (WPS) to add a wireless
device or computer to your network (see
page 19. The WPS LED blinks for 2 minutes during this process.
Wi-Fi Protected Setup (WPS) Method
Hardware Setup
9
on