Functional Description - Makita 6952 Instruction Manual

ENGLISH
1 Switch trigger
2 Reversing switch lever
3 Bit
4 Sleeve
SPECIFICATIONS
Model
Capacities
Machine screw....................................... 4 mm – 10 mm
Standard bolt ........................................ 6 mm – 14 mm
High tensile bolt .................................... 6 mm – 10 mm
–1
No load speed (min ) ...................................... 0 – 3,300
Impacts per minute ........................................... 0 – 3,300
Max. fastening torque ........................................ 120 N•m
Dimensions (L x W x H) ...... 229 mm x 67 mm x 180 mm
Net weight............................................................... 1.3 kg
Safety class .............................................................
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety Hints
For your own safety, please refer to the enclosed safety
instructions.
ADDITIONAL SAFETY RULES FOR TOOL
1. Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Con-
tact with a "live" wire will also make exposed
metal parts of the tool "live" and shock the oper-
ator.
2. Hearing protection should be worn when operat-
ing in impact conditions.
3. Hold the tool firmly.
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
SAVE THESE INSTRUCTIONS.
Explanation of general view
5 Hook
6 Fastening time
7 Screw size
8 Limit mark

FUNCTIONAL DESCRIPTION

6952
CAUTION:
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Switch action (Fig. 1)
CAUTION:
Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the "OFF"
position when released.
/II
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Holding the tool
Hold the tool only by the handle when performing an
operation. Do not touch the metal part.
Reversing switch action (Fig. 2)
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for counter-
clockwise rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
ENB058-1
unplugged before carrying out any work on the tool.
Installing or removing driver bit or socket bit
(Fig. 3 & 4)
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the sleeve,
the sleeve will not return to its original position and the
bit will not be secured. In this case, try re-inserting the
bit according to the instructions above.
9 Screwdriver
10 Brush holder cap
5