Determining The Wireless Network Settings; Wireless Installation Using Usb Connection - Dell 3110CN Owner's Manual

Determining the Wireless Network Settings

You need to know the settings for the wireless network to set up the wireless printer. For details of
the settings, contact your network administrator.
Wireless
Settings
Security
Settings

Wireless Installation using USB connection

NOTE:
printer.
Scene 1. Install a printer to the already-operating wireless network (When wireless setting is already
set to your computer)
Insert the
1.
Drivers and Utilities
The
2.
If the CD does not automatically launch, click Start
is the drive letter of your CD), and then click OK.
Select the Network Installation option button, and then click Next.
3.
Select the Configure Wireless Printer using a USB connection (Recommended) option
4.
button, and then click Next.
Reset the wireless setting of the printer following the steps on the Reset Wireless Setting
5.
screen.
In the list on the Select Printer screen, check the check box of the target printer that you are
6.
making wireless setting for, and then click Next. On the Enter Wireless Network Settings
screen, set each wireless setting item, and then click Next. When you select the Fixed IP
option button for IP address assignment, click Settings... and enter the IP address and subnet
mask on the screen.
NOTE:
Set each item on the Enter Printer Settings screen, and then click Next.
7.
32
Setting up Network Printing
SSID Specifies the name () that identifies the wireless network. Up to 32
alphanumeric characters.
Network Type Specifies the network type from Ad-hoc or Infrastructure.
Security Selects the security method from No security, WEP , WPA-PSK
TKIP and WPA-PSK AES.
Transmit Key Specifies the transmit key from the list.
WEP Key Specified the WEP key set used through the wireless network only
when WEP is selected for Security.
Pass Phrase Specifies the pass phrase of alphanumeric characters from 8 to 63
bytes long only when WPA-PSX is selected for Encryption.
The optional multi protocol card with the Wireless LAN Adapter attached must be installed on the
Drivers and Utilities
CD should launch the installation software automatically.
When you enter a fixed IP address, avoid the "169.254.xxx.xxx" address used by AutoIP.
CD into your computer.
→
Run, type D:\Setup.exe (where D