Fleetsync: Alphanumeric 2-Way Paging Function; K Ey F Unctions - Kenwood TK-5710 Series Instruction Manual

FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION

FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by
KENWOOD Corporation. FleetSync enables a variety of paging functions on your
transceiver, some of which depend on dealer programming.
Note: This function is available only in Conventional FM Operation.
K F
ey uncTionS
Key
Selcall or Selcall + Status
CH control
PTT switch or PF 4 key
Keypad 0 ~ 9
PF 3 or DTMF # key
PF 2 or DTMF
PF  key
Press Selcall or Selcall Status
Selcall Mode
Press PF2
Press
Status Mode
PF1
 Depending on how your dealer programmed the transceiver, Selcall mode may be skipped or the
transceiver may exit Selcall mode automatically (as shown by the dash arrow).
2 After entering Selcall mode by pressing the Selcall + Status key, you can enter Status mode by
pressing the PF2 key.
Press to change the transceiver mode as shown in
the diagram below.
Rotate to select an ID from the pre-programmed ID
list or Status list.
Press to initiate a call.
Use the DTMF keypad to enter Selcall or Status
numbers.
When dialing a number manually, press to delete a
character or press and hold to delete all characters.
Press to exit Selcall or Status mode. Press and
hold to toggle between list selection and manual
entry (if enabled). In Stack mode, press to toggle
key
the display between ID/message, receive channel,
and time stamp, or to delete the selection.
Press to exit Selcall or Status mode.
Normal Operating Mode
Receive a
new message
New Message
1
Display Mode
2
Function
Hold Selcall, Status
or Selcall Status
Press
any key
Press PF1
Stack Mode
9