Table of Contents
Advertisement
Troubleshooting
5.
This chapter gives information about troubleshooting your NETGEAR Wireless Cable Gateway.
For the common problems listed, go to the section indicated.
Have I connected the gateway correctly?
•
Go to
"Basic Functions"
I cannot access the gateway configuration with my browser.
•
Go to
"Connecting to the Gateway's Main Menu"
I have configured the gateway but I cannot access the Internet.
•
Go to
"Troubleshooting the ISP Connection"
I cannot remember the gateway's configuration password or I want to clear the
•
configuration and start over again.
Go to
"Factory Default Settings" in Appendix
NETGEAR provides helpful articles, documentation, and the latest
Tip:
software updates at http://www.netgear.com/support.
Basic Functions
After you have turned on power to the gateway, you should do the following:
Check to see that the Power LED is on.
1.
Check that the numbered Ethernet LEDs come on momentarily.
2.
After a few seconds, check that the local port link LEDs are lit for any local ports that are
3.
connected.
If any of these conditions does not occur, refer to the appropriate following section.
on page 38.
on page 40.
on page 39.
A.
Chapter : Troubleshooting
5
| 38
Advertisement
Table of Contents
Troubleshooting
