Advanced Wireless Settings - NETGEAR CG3000D-1CXNAS User Manual

Wireless Cable Gateway CG3000D-1CXNAS

Advanced Wireless Settings

You can use the Advanced Wireless Settings screen to configure the wireless radio settings,
and other advanced settings:
The following table describes the fields in the Advanced Wireless Settings screen.
Advanced Wireless Settings
Wireless Access
Point (Enhanced
Feature)
Advanced
Configuration
WPS Settings
Wireless Card
Access List
Enable Wireless Access Point By default this checkbox is selected so that the
Fragmentation Threshold
•
CTS/RTS Threshold
•
Preamble Mode
•
Disable Router's PIN
Keep Existing Settings
Set up Access List
Description
gateway works as a wireless access point. You can
turn off the wireless radio to disable access through
this device. This can be helpful for configuration,
network tuning, or troubleshooting activities.
The default settings for these fields usually work fine.
Change them only if you have a specific reason for
doing so.
Selecting this checkbox disables the PIN that WPS
clients use to connect to the gateway with the PIN
method. Normally this checkbox is cleared, which is
the default setting.
If a WPS client is added the gateway automatically
selects this checkbox. When the Keep Existing
Settings checkbox is selected, the SSID and wireless
security settings remain the same when additional
WPS clients are added.
Access control is disabled by default so that any
computer that is configured with the correct SSID
can connect. For information about access control,
see the following section.
Chapter 2: Wireless Configuration | 17