Add Or Edit An Auto Vpn Policy - NETGEAR N750 DGND4000 User Manual

N750 Wireless Dual Band Gigabit ADSL Modem Router DGND4000
• Cancel. Discard any unsaved changes to the Enable setting for each policy.
• Add Auto Policy. Change to the input screen for an Auto policy. When the new policy
is saved, it appears in the bottom row of the Policy Table. See
VPN Policy
• Add Manual Policy. Change to the input screen for a Manual policy. When the new
policy is saved, it appears in the bottom row of the Policy Table. See
Manual VPN Policy

Add or Edit an Auto VPN Policy

An Auto VPN policy uses the IKE (Internet Key Protocol) to exchange and negotiate
parameters for the IPsec SA (security association). Because of this negotiation, not all of the
settings on this VPN gateway have to match the settings on the remote VPN endpoint.
Where settings have match, this requirement is indicated.
To add or edit an Auto VPN Policy:

1. Click ADVANCED > Advanced Setup > VPN Policies.
2. Click the Add Auto Policy button.
3. Enter or select the following parameters:
• General. These settings identify this policy and determine its major characteristics.
- Policy Name. Enter a unique name to identify this policy. This name is not
supplied to the remote VPN endpoint. It is used only to help you manage the
policies.
- Remote VPN Endpoint. If the remote endpoint has a dynamic IP address, select
Dynamic IP Address. No address data input is required.
on page 131.
on page 134.
Advanced Settings
131
Add or Edit an Auto
Add or Edit a