Using A Usb Mouse - Honeywell HRG4 User Manual

30 | Performance Series DVR User Guide
Configuring the IR Remote Control
Aim the remote control at the IR receiver located at the front of the unit to test operation. If there
is no response, try the following steps:
1.
2.
3.
4.
5.
The Status indicator on the front panel should turn green to indicate that the remote control is
operating properly.

Using a USB Mouse

A regular 3-button (Left/Right/Scroll-wheel) USB mouse can also be used with this HRG DVR.
Connecting a USB Mouse
•
The mouse should automatically be detected. If, in a rare case, that the mouse is not detected,
pleased refer to the recommended device list from your provider.
USB Mouse Controls
www.honeywellvideo.com
Use the front control panel or the mouse to navigate to Menu
More Settings.
Check and remember the HRG DVR ID number. The default ID number is 255. This ID
number is valid for all IR remote controls.
Press DEV on the remote.
Enter the DVR ID number from step 2.
Press ENTER on the IR remote control.
Plug the USB mouse into one of the USB ports on the front panel of the HRG DVR.
Table 1-3 Mouse Controls
Control Action
Single click
Double click
Left button
Click and drag
Right button Single click
Scroll up
Scroll wheel
Scroll down

Result
Select a menu component, such as a button or an
input field. This is similar to pressing the ENTER
button on the remote/front panel controls.
Switch between single screen and multi-screen
mode in Live View/ Playback mode.
Click and drag the Left mouse button to control the
pan/tilt of a PTZ camera as well as to vary the
position of the digital zoom area and the camera
OSD. It can also be used to setup the alarm areas.
Shows pop-up menu.
In Live View mode, scrolling up will switch to the
previous screen. In Menu mode, it will move the
selection to the previous item.
In Live View mode, scrolling down will switch to the
next screen. In Menu mode, it will move the
selection to the next item.
 
Settings General