Table of Contents
Advertisement
Chapter 3
Maintaining the Server
Install the power cable adapter:
Step 4
Disconnect the PCIe power cable from the motherboard. This is 10-pin connector J166 (see
a.
Figure
Connect the male 10-pin connector of the power cable adapter to the motherboard connector J166.
b.
Connect the PCIe power cable into the female 10-pin connector on the power cable adapter, which
c.
you attached to the card in
Step 5
Replace the top cover.
Replace the server in the rack, replace power cords and any other cables, and then power on the server
Step 6
by pressing the Power button.
Figure 3-32
1
1
Six-pin connector to GPU card
2
Ten-pin male connector to motherboard
socket J166
OL-22326-01z
3-32).
Step
2.
Installing and Cabling the GPU Card
2
3
3
2
Installing or Replacing Server Components
3
Ten-pin female connector to PCIe power cable
Cisco UCS C460 Server Installation and Service Guide
3-49
Advertisement
Table of Contents
