Table of Contents
Advertisement
Important Note:
In order to ensure proper cooling of the Beacon Controller, the unit needs to be in-
stalled vertically in a well ventilated place (avoid to mount it in sealed boxes).
Connection Compartment
All of the wiring and configuration functions such as:
•
Connection of the IS76 Ferrite Antenna(s)
•
Connection of the wired supervision output
•
Setting of the Location identification code
Can be carried out in the connection compartment. It is reached by taking off the lower part
of the housing (see). This can be done even if the device is fixed on the wall.
The connection cables can be channelled towards the outside through the hole next to the
terminal blocks or downwards by breaking off part of the rear housing.
Connection of the power supply can be done without taking off the lower part of the housing.
Enable Locator Function in NurseCall System
In order to be operational, the Locator function has to be enabled in the NurseCall Main Unit
(refer to section "Selection Locate Function YES or No" in the NurseCall User Manual)
__________________________________________________________________________________________________________________
Edition: October 2013 Document N°: F.01U.136.807 V2
80
13.1
53.8
131
Figure 3
3.7
16
6.6
27
59.9
18.1
26
2
Page 7 of 10
Advertisement
Table of Contents
