Table of Contents
Related Manuals for Bosch IS76
Summary of Contents for Bosch IS76
-
Page 1: Is76 Beacon With Ferrite Antenna
IS76 Beacon with Ferrite Antenna Installation Manual __________________________________________________________________________________________________________________ Edition: October 2013 Document N°: F.01U.136.807 V2 Page 1 of 10... - Page 2 Document No F.01U.136.807 V2 IS76 Beacon with Ferrite Antenna: Installation Manual Edition: October 2013 Editor: TeleAlarm SA All rights reserved. TeleAlarm SA reserves the right to make changes to the information contained in this document at any time without prior notice. Great care has been given to the contents of this document; however...
-
Page 3: Table Of Contents
IS76 Beacon with Ferrite Antenna ........................ 4 IS76 Ferrite Antenna............................4 IS76 Ferrite Beacon Controller ........................5 System Supervision ............................5 Features of the IS76 Beacon System ......................5 IS76 Ferrite Antenna ............................6 IS76 Beacon Controller ............................. 6 Connection Compartment ..........................7 Enable Locator Function in NurseCall System .................. -
Page 4: Locator Function
The NurseCall system can be set to handle a Locator function. For this purpose, beacon modules and antennas of type IS75 or IS76 need to be installed on doors or corridors in the building you want to supervise. When passing one of these modules the Wristband Transmit- ters of type S37L or the Pendant Transmitters of type S35L refresh the position information that is stored into them. -
Page 5: Is76 Ferrite Beacon Controller
The IS76 Ferrite Beacon Controller is necessary to drive the IS76 Ferrite Antenna. It con- nects to the mains power via an external power supply. Up to two IS76 Ferrite Antennas may be connected to the IS76 Beacon Controller, depending on the size of the passage that has to be covered with the beacon. -
Page 6: Is76 Ferrite Antenna
1.5 cm away from metallic frames or surfaces. IS76 Beacon Controller The IS76 Beacon Controller can be fixed with two to five screws on the wall. Two holes at 60 mm interval are provided for direct mounting on connection boxes. -
Page 7: Connection Compartment
(avoid to mount it in sealed boxes). Connection Compartment All of the wiring and configuration functions such as: • Connection of the IS76 Ferrite Antenna(s) • Connection of the wired supervision output •... -
Page 8: Configuration And Wiring
Configuration and Wiring *Antenna B is optional It is used to extend the capture range on large (double) doors Supervision Signal Lamp: Green: ok Red: operation failure Position number: *Polarity of the antenna and the wiring has to be respected when two antennas are used for the... -
Page 9: Ferrite Beacon Antenna
Ferrite Beacon Antenna Housing Operation Range Plastic case ASA for wall mounting L x H x P 600 x 30 x 30 mm Weight about 700 g Connecting cable 2 m "twisted pair" (may be extended up to 10 m) typ. - Page 10 FCC Statement for Class B digital device Note: This equipment has been tested and found to comply with the limits for a Class B digital de- vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.