Wpa-Psk/Wpa2-Psk - ZyXEL Communications NBG-416N User Manual

Chapter 6 Wireless LAN
Table 29 Network > Wireless LAN > General: Static WEP (continued)
LABEL
Apply
Reset

6.4.3 WPA-PSK/WPA2-PSK

Click Network > Wireless LAN to display the General screen. Select WPA-PSK
or WPA2-PSK from the Security Mode list.
Figure 53 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 30 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA
Compatible
Cipher Type
Pre-Shared Key
80
DESCRIPTION
Click Apply to save your changes back to the NBG-416N.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Choose WPA-PSK or WPA2-PSK from the drop-down list box.
This check box is available only when you select WPA2-PSK in the
Security Mode field.
Select the check box to have both WPA2 and WPA wireless clients be
able to communicate with the NBG-416N even when the NBG-416N is
using WPA2-PSK.
Select the encryption type (TKIP, AES or TKIP+AES) for data
encryption.
Select AES if your wireless clients can all use AES. Otherwise, select
TKIP or select TKIP+AES to allow the wireless clients to use either
TKIP or AES.
WPA-PSK/WPA2-PSK uses a simple common password for
authentication.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols).
Type a pre-shared key less than 64 case-sensitive HEX characters ("0-
9", "A-F").
NBG-416N User's Guide