Troubleshooting - Sony DWTB01/E1424 Operating Instructions Manual

Troubleshooting

If you encounter a problem using this transmitter, use the following checklist to find a
solution. For any problems with the receiver or adapter, refer to the operating instructions
supplied with the respective device. If the problem persists, consult your Sony dealer.
Symptom Meanings
The transmitter The batteries are inserted
does not turn backwards in the battery
on. compartment.
The batteries are exhausted.
The batteries Manganese batteries are being
drain quickly. used.
The transmitter is being used
under cold conditions.
Interruptions in The transmitter is too far from
the reception the receiver.
occurs.
The transmission power setting
is set to "L: 1mW".
There is no The channel setting on the
sound. transmitter is different from that
on the receiver.
The setting of the encrypted
transmission function on the
receiver is different from that on
the transmitter.
The sound is The audio input level of the
weak. transmitter is set to LINE or the
attenuation level is too high.
There is The attenuator is set too low for
distortion in the the audio input level of the
sound. transmitter.
The bass is The frequency of the low-cut
weak. filter is set too high.
Remedy
Reinsert the batteries with the
correct orientation (see page 9).
Replace the batteries with new
ones.
Use alkaline batteries.
The batteries drain quickly under
cold conditions.
Decrease the distance to the
receiver and check the reception.
Increase the transmission power
(see page 19).
Use the same channel setting on
both the transmitter and receiver.
Confirm that the setting of the
encrypted transmission function is
the same on both the transmitter
and the receiver (see page 14).
If a microphone is connected to
the transmitter, set the audio input
to MIC (see page 19). While
monitoring the audio input level
meter, set the attenuator to an
appropriate level.
While monitoring the audio input
level meter, set the attenuator to a
level that does not produce
distortion.
While monitoring the sound,
decrease the low-cut filter
frequency to a level that produces
the proper sound quality (see page
20).
Troubleshooting 25