Table of Contents
Advertisement
Configuring a DWX System
Flowchart for Step 3
Checking the service area with one channel
Flowchart for Step 4
Checking third-order intermodulation distortion
Flowchart for Step 5
Checking simultaneous multi-channel operation
Setup procedure is complete.
54
Making and Checking RF Settings (UHF)
From Step 2
Make parameter settings and power
up only TX for desired channel
Check whether service area is
achieved for desired channel
(single channel)
All combinations tried?
Yes
Power down only desired channel TX
Check third-order intermodulation
distortion noise level
Combination clearing
requirements of step 3 was
determined?
Yes
Power up all transmitters
Check service area for desired
channel
Combination clearing
requirements of step 4 was
determined?
Yes
Is there a combination
that fulfills the service area
requirements?
Yes
Among the combinations that fulfills
the service area requirements, select
the one that best matches the
operation conditions.
Change TX RF power and RX ATT
level parameters
No
Change TX RF power and RX ATT
level parameters
No
Change TX RF power and RX ATT
level parameters
No
No
Return to of step 2
Advertisement
Table of Contents
