Configuring a DWX System
Flowchart for Step 2
Selecting the desired channel
Antenna installation and setup
50
Making and Checking RF Settings (UHF)
From Step 1
Power up all TX except for one.
Check third-order intermodulation
distortion noise level
Designate channel with highest noise
level as desired channel
Power up only desired channel TX
Check service area for desired
channel (single channel)
Sufficient service area
achieved?
Yes
To Step 3
Power down a different TX
Optimize antenna installation
conditions
1. Determine Antenna installation
location/orientation
2. Determine antenna gain
3. Determine number of antennas
No