Table of Contents
Advertisement
Settings
Configuring Settings
Perform the following to configure settings.
1.
Connecting the computer (required)
2.
Changing the password
3.
Network settings (required)
4.
Format settings (required)
5.
Video transmission settings (required)
6.
Synchronization settings (required)
7.
Transmission rate settings (required)
8.
Audio signal settings (required)
9.
Tally signal settings (required)
10. GPIO settings (required)
11. Date and time settings
12. Changing the web menu title
13. Backing up and restoring settings
14. Importing and exporting settings
15. Verifying settings
16. Verifying the network environment
1. Connecting the computer
A computer can be connected to this unit's CONTROL
connector using a LAN cable (either straight or cross).
Open a web browser on the computer, and enter "http://
192.168.0.3" (or an amended IP address) in the address
field.
The web menu used to configure this unit appears.
Note
When configuring settings, be sure to click the [Apply]
button after configuring settings in each web menu page.
If you switch to a different page or close the web browser
without clicking the [Apply] button, the settings will not
be applied.
The factory settings for this unit's CONTROL connector
are as follows.
IP address: 192.168.0.3
LAN cable
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.253
The network settings can be checked via the [Status] page
of the web menu or via the text information superimposed
on the monitor output.
2. Changing the password
User names and passwords can be changed on the
[Others] page.
Password entry is required to display pages other than the
[Status] page and [Operator] page. The factory default
user name and password are as follows.
User name: Users
Password: NXL-IP55
3. Network settings
The network settings are configured on the [Network]
page.
Settings must be configured for the MAIN connector
network, which transmits the main line signal, and the
CONTROL connector network, which connects to the
computer used to setup this unit.
MAIN connector settings
These are configured under [Main Port Configuration] on
the [Network] page.
Although it is one connector, it has two IP addresses –
Main 1 and Main 2. When you configure the IP address
for Main 1, a sequential IP address is configured for Main
2 automatically. Make sure that the IP addresses do not
overlap with other devices.
• [Host IP Address (1/2)]: Enter the IP address for Main
1.
• [Host IP Address (2/2)]: This is configured
automatically when you enter an address for [Host IP
Address (1/2)]. This cannot be modified.
• [Subnet Mask]: This setting is the same for Main 1 and
Main 2.
• [Destination IP Address (1/2)]: Enter the Main 1 IP
address of the other connected NXL-IP55 unit (i.e., the
connection destination).
• [Destination IP Address (2/2)]: This is configured
automatically when you enter an address for
[Destination IP Address (1/2)]. This cannot be
modified.
• [Speed]: Displays the connection speed.
• [Stream Mode]: Set to "Multicast" if using the PC
application software (optional), or set to "Unicast"
otherwise.
Note
In Multicast mode, multicast packets are sent from the
switch to all ports, which may affect communication on
other ports. In order to avoid this, use the IGMP
snooping function and IGMP query function of the
switch to monitor traffic, or take other measures such as
segmenting the network connected to the MAIN
connector and the network with the CONTROL
connector using VLANs.
11
Settings
Advertisement
Table of Contents
