Operating Tips - Maytag 9922 User Manual

Operating lips .......................................................
Starting The Dishwasher To Set Up a Delay:
[] After loading the dishwasher and adding detergent, [] Select the appropriate cycle and options for the
close the dishwasher by pressing the door until the load.
latch clicks. [] Then quickly press and hold the Delay/Resume pad
] If the water heater is located a long distance from until the desired amount of delay time is displayed.
the dishwasher, run the water from the hot water tap [] The DELAY indicator will remain lit until the clock
to clear the line of cold water.
has counted down.
[] Firmly press the desired cycle and OPTIONS pads [] The cycle will automatically start as soon as the
to start the dishwasher ( fill will begin), delay time expires.
[] The indicator light for the selected cycle will glow.
I Note; If delay is chosen without first selecting a
Note: Water heating and dry options can be used cycle and/or options, the dishwasher will select the
separately or together, last wash cycle used in the delay mode.
Adding a Forgotten Item To Cancel a Delay:
For best cleaning, the forgotten item should be added Press the Delay/Resume pad again. The indicator light
,o early in the cycle, will go out and the cycle will start immediately.
] Unlatch the door.
To Temporarily Interrupt a Cycle:
,, [] Wait for the water circulation to stop.
[] Open the door and add the item. [] Press the Delay/Resume pad.
[] Close and latch the door, [] The cycle will stop.
[] The cycle resumes automatically. [] The cycle will resume from the point of interruption
when the delay time expires or when the
Delay/Resume pad is pressed again.
_eeoeeooleoeeoeeoeoo*leoQeeo*leeleeoeooolooeeooetoee
Display Window
WASH light glows during all wash portions. HEATING DELAY glows to indicate that the cycle is
RINSE light glows during all rinse portions, being extended to heat the water to proper temperature
RINSED ONLY (certain models) appears after
DRY light glows during the entire dry period and goes
out when the cycle is completed. RINSE & HOLD cycle.
PF appears when there has been a power failure. Pres
CLEAN glows at the end of the dry cycle and remains
_* lit until the door has been open for 30 seconds coutinu- any option pad (Temp Sense, Heated Dry or Sani Heat
one time to clear the display.
oasly.
DELAY glows when this option is selected. The light
stays on until the start of the cycle.
9