Operating Tips; Starting The Dishwasher; Adding A Forgotten Item - Maytag MDB5100 User Manual

Controls at a Glance (continued)
.................................
Control Lock Option
The control touchpads can be locked to prevent unwanted
use. If this feature is activated between cycles, the dish-
washer cannot be operated until the controls are unlocked.
If desired, the controls can be locked after a cycle or delay
has started.
Note: This option does not lock the door, only the dish- I
washer controls.
I
Setting the Control Lock:
[] Press thet_pad for three seconds.
_'_ An indicator light above the pad will illuminate when
the controls are locked.
To Cancel:
_i Press the _pad for three seconds.
[ The indicator light will go off.
Operating
I Note: If a cycle or option pad is pressed after the con-
trois have been locked, the indicator light above the
Control Lock pad will flash five times.
Starting The Dishwasher
B After loading the dishwasher and adding detergent,
close the dishwasher by pressing the door until the
latch clicks.
[ To start the dishwasher, firmly press the desired
cycle and options pads. After a pause, the fill will
begin. To prevent unplanned cycle or option
changes, these selections are "locked in" after 1
minute.
D The indicator for the selected and
lights cycle
options will glow.
InTo cancel an option, press the pad again. To cancel
a cycle, press the Drain/Off pad.
I
Note: If a cycle or option pad is pressed after the
I
selections are "locked in", the indicator light above
I
the Control Lock pad will flash five times.
Adding a Forgotten Item
For best cleaning, the forgotten item should be added early
in the cycle.
D Press the unlatch the door.
Delay/Resume
pad or
F_Wait water to stop.
for the circulation
[]Open the door and add the item.
[]Close and latch the door.
• If Delay/Resume was pushed, push it again to
restart the dishwasher.
[]After five seconds, the cycle resumes automatically at
the point of interruption.
I Note: Extended interruption of the wash cycle is not I recommended.
I
7