Installing The Cisco Unified Ip Phone - Cisco 7931G Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone

Installing the Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See
Figure 3-1
Perform the steps shown in
Table 3-1 Installing the Cisco Unified IP Phone
Installation Step
Step 1
Connect the handset to
the Handset port.
Step 2 Connect a headset to
the Headset port.
Step 3
Connect the power
supply to the Cisco DC
Adapter port.
Step 4
Connect a Category 3
or 5 straight-through
Ethernet cable from
the switch to the
10/100 SW port.
Step 5 Connect a Category 3
or 5 straight-through
Ethernet cable from
another network
device, such as a
desktop computer, to
the 10/100 PC port.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP and SIP)
OL-18988-01
for a graphical representation of the connections.
Table 3-1
Notes
—
Optional. You can add a headset later if
you do not connect one now.
Optional.
Each Cisco Unified IP Phone ships
with one Ethernet cable in the box.
Optional. You can connect another
network device later if you do not
connect one now.
to install a Cisco Unified IP Phone.
Reference
—
See the "Headset" section
on page 3-3
headsets.
See the "Providing Power
to the Phone" section on
page 2-3.
See the "Network and
Access Ports" section on
page 3-2 for guidelines.
See the "Network and
Access Ports" section on
page 3-2 for guidelines.
Installing the Cisco Unified IP Phone
for supported
3-5