Cisco DPC User Manual page 32

How Do I Configure My DOCSIS Residential Gateway?
Configuring Network Time Synchronization
Use the Basic Settings Enable/Disable time synchronization by Network Time
protocol page to enable or disable time synchronization by Network Time protocol.
Note: If you are not familiar with the time configuration procedures detailed in this
section, contact your service provider before you attempt to change any of the
residential gateway default time synchronization configuration settings.
Click Set Time in the Basic Settings section of the Setup page to access the Basic
Settings Enable/Disable time synchronization by Network Time protocol page.
Setup Basic Settings - Enable/Disable Time Synchronization by
Network Time Protocol
The following illustration is the initial view of the Basic Settings Enable/Disable
time synchronization by Network Time protocol page.
32 4024320 Rev A