Time Code Output - Sony HVR-M35U Operating Instructions Manual

Time Code Output

Time code can be output from the TC OUT jack, HD/SD
SDI OUT jack and/or the
playback/recording or in EE mode.
Time code output during playback
Time codes recorded on the tape are output.
Time code output during recording or in
EE mode
Time codes generated by the time code generator of the
unit, or time codes input from external equipment are
output.
Notes
• During recording in 1080/24p, the 30-frame rate time
codes are output after conversion.
• To output a 1080/24p signal without frame rate
conversion of the time code, output it from the HDV/
DV jack without down-conversion.
• When [JOG TC OUT] is set to [OFF] in EE mode, time
codes may not be output.
• Time codes via the TC OUT jack are output with the
same timing as that of the phase of the output signals
from the COMPONENT OUT jack. (In the NTSC
mode, or when the signals output from the
COMPONENT OUT jack are in 720p or 1080i format,
the timing of the time codes is three lines earlier than
the phase of S VIDEO OUT/VIDEO OUT signals.)
58
Chapter 3 Utilizing the Time Code
HDV/DV jack during