Chapter6 Maintenance; Cleaning; Cleaning And Vacuuming The Printer - Fujitsu DL3750+/3850+ User Manual

CLEANING

User's Manual
MAINTENANCE
Your printer requires very little care. Occasional
cleaning and replacement of the ribbon cartridge
are all that is required.
Lubrication of the printer is not usually necessary.
If the print head carriage does not move smoothly back and forth, clean the
printer as described in this chapter. If the problem continues, contact your
dealer to determine whether lubrication might be needed.
The front and back covers, the ejection cover, and the acoustic cover of the
printer help protect against dust, dirt, and other contaminants. However,
paper produces small particles that accumulate inside the printer. This
section explains how to clean and vacuum the printer and how to clean the
platen and paper bail rollers.
It is easier to clean the printer when the front cover, the ejection cover, and
the cut sheet stand and back cover are removed.

Cleaning and Vacuuming the Printer

WARNING
To avoid any possibility of injury, before cleaning the printer, turn off the
power to both the printer and the computer, and unplug the printer.
Use the following procedure to clean and vacuum the printer as required:
1. Remove any paper from the printer. Make sure that the power is off,
and then disconnect the printer power cord.
2. Using a soft vacuum brush, vacuum the exterior of the printer. Be
sure to vacuum the air vents at the front, left sides, and bottom of the
printer. Also vacuum the cut sheet stand.
MAINTENANCE
6
6-1