D-Link DGS-6600-48TS Quick Installation Manual page 8

Connecting the Serial Cable of the Man-
agement Module
Simple CPU Module Cable Connection
1. Connect the RJ45 connector of an Ethernet
cable to the Ethernet port of the Switch's
management module (DGS-6600-CM) and
connect the other end of the cable to any
TCP/IP capable device that is able to exe-
cute Telnet or SSH.
- or -
2. Connect the standard DB9 end of the
serial cable to the RS-232 serial port of
the Switch's management module and the
other end to the PC/Notebook or control
terminal.
- or -
3. Connect a USB cable with a USB Standard
B Connector to the Standard B receptacle
on the Switch's management module. Con-
nect the other end to a computer equipped
with a USB port capable of supporting a
serial interface using the PL-2303 USB
Serial Driver SW from Prolific Technology
Inc..
Removing Boards from the DGS-6604
Carry out the following steps to remove boards
from the DGS-6604:
1. Unplug all copper/fiber cabling, i.e. RJ45
twisted-pair and fiber optic cables, from the
board to be removed.
2. Loosen and unscrew the panel's two cap-
tive screws.
3. Use both hands to pull the levers, on the
left and right hand sides of the board, to
remove the board from the DGS-6604, as
shown in the following diagram.
8 u D-Link DGS-6604 Modular Switch
Caution
Before removing/adding a board,
always wear an anti-static wrist
strap.
Take care not to hold the edge of
the PCB or collide the components
of the PCB..
Figure 9. Removing a board from the chassis
Installing Boards on the DGS-6604
Carry out the following steps to install boards
in the DGS-6604:
1. Remove the component card or blank panel
as instructed in the section.
2. Insert the new board into the guide rail of
the vacant slot.
3. Use the levers on the left and right hand
side to push the board into position and
tighten the two captive screws on the board
using a straight screw driver.
Caution
1. Take care not to hold the
edge of the PCB or collide the
compo nents of the PCB.
2. Always use the levers to plug/
unplug a PCB module. Never
use force to remove a PCB
module.