Epson STYLUS PRO 9000 User Manual page 124

o= On, f= Flashing, n= Off
Message and Light
PUSH LEVER DOWN
oPaper Out
REMOVE PAPER
oPaper Out
UNABLE TO PRINT
INK OUT
oY/LM/M/LC/C/K
NO INK
CARTRIDGE
oY/LM/M/LC/C/K
WRONG
CARTRIDGE
oY/LM/M/LC/C/K
OPTION I/F ERROR
Problem
Paper set lever was
released during the
printing process or
another operation.
Paper set is too thick
for head cleaning.
While an error occurs,
or the ink
compartment cover
is open, you try to print
a test pattern (nozzle
check, status check,
head alignment, or
paper thickness
pattern) from the
SelecType settings.
Ink cartridge(s) is (are)
empty.
Ink cartridge(s) is (are)
not installed.
Wrong ink cartridge(s)
is (are) installed.
Wrong I/F card is
installed.
Solution
Push the paper set lever
down. Start printing
again from the
beginning for best
results.
Push the paper set lever
down to remove the
paper. Head cleaning
automatically starts.
After cleaning, when
is displayed,
reload paper.
After 3 seconds the
message disappears.
Press the Pause button to
exit the SelecType
mode. When an error or
status message appears
again, clear and
perform printing a test
pattern again.
Replace the ink
cartridge(s) as indicated
by the lights. See
"Replacing Ink
Cartridges" on page
104.
Install ink cartridge(s) as
indicated by the lights.
See "Replacing Ink
Cartridges" on page
104.
Use the correct ink
cartridge(s).
Install the correct I/F
card after turning off the
power.
Troubleshooting
124