Troubleshooting Guide - Canon EOS Rebel Ti SERIES Instructions Manual

Reference

Troubleshooting Guide

If there is a problem, try to resolve it by referring to this Troubleshooting Guide. If
the problem still persists, take the camera to your nearest Canon Service Center.
Nothing is dis-
played on the
LCD panel.
The picture
looks blurred.
The shutter
does not work.
The < >
icon blinks on
the LCD panel.
When using an external flash unit, an EOS-dedicated Speedlite is recom-
mended. Using the camera with a flash unit (equipped with electrical contacts
on the hot shoe foot), high-voltage flash unit, or flash accessories dedicated
to a different brand may result in camera misoperation or malfunction.
56
The batteries are exhausted.
Replace the batteries with new ones. (→page 14)
The batteries have been installed incorrectly.
Install the batteries correctly. (→page 14)
The lens focus mode is set to <
Set the lens focus mode to <
There was camera shake when the picture was taken.
Hold the camera steady or use a faster shutter speed.
(→page 17)
The frame count is not displayed on the LCD panel.
Take out the film and load it correctly. (→page 18)
The < > icon blinks on the LCD panel.
Replace the batteries with new ones. (→page 14)
The < > icon blinks while the rewound film is still in the
camera.
Replace with a new roll of film. (→page 18)
The focus confirmation light <
and focus cannot be achieved.
Select another AF point. (→page 32)
If focus still cannot be achieved, focus manually. (→page 34)
The battery level is very low.
Replace the batteries with new ones. (→page 14)
A misoperation has occurred.
Press the shutter button halfway. (→page 17)
Remove the batteries and reload it. (→page 14)
If the blinking <
your nearest Canon Service Center.
MF
> (or <
AF
>. (→page 16)
> in the viewfinder blinks
> icon does not turn off, consult
M
>).