Troubleshooting Guide
If you have a problem with the camera, first refer to this Troubleshooting
Guide.
Problem
Probable Cause
Solution
Page
4. Nothingis | ?9 belteres are exhausted. | Replace he batteries with
"
displayed
:
on the LCD | тһе batteries have been
Install the batteries correctly.
6
panel.
installed incorrectly.
1
The іт has not been loaded | Load the film correctly.
correctly. (The frame No. is not
20
displayed on the LCD panel.)
Rewound film is still in the | Take out the film cartridge
camera. (The frame counter | and load a new roll of film.
20
2. The shutter | on the LCD panel is blank.)
does not
release.
| Focus has not been achieved. | Press the shutter button
(The in-focus indicator in the | halfway until focus is
viewfinder is blinking.)
achieved. If focus still cannot
be achieved, set the focus
19
mode switch on the lens to
2
MF (or M) and focus manually
with the focusing ring.
The focus mode switch on the | Set the focus mode switch on
ae
lens was set to MF (or М).
| the lens to AF.
18
. The
|
photograph
The shutter speed was too
| Press the shutter button
pour 9
slow to prevent blur caused | gently while holding the
38
:
by camera shake.
Camera steady or use a faster
shutter speed.
The battery level is very low. | Replace the batteries with
пем ones and check that $ is | 17
displayed on the LCD panel.
4. Only
is
| For some reason, the camera | Press the shutter button
blinking оп | is not operating properly. ^ |halfway. The camera should
the LCD
return to normal.
17
panel.
"the 0 iconisstlldspayed
| Buck
alter you execute the above
ber
procedure, the camera needs
repair. Take it to the nearest
Canon Service Center.
66