For Vigor2850Vn - Draytek Vigor2850 Series User Manual

1 . 2 . 3 F o r V i g o
1 . 2 . 3 F o r V i g o
LED
ACT (Activity)
USB
WAN2
WLAN
ADSL
VDSL
Line
Phone 1/2
LED on Connector
GigaLAN 1/2/3
GigaLAN 4/WAN
(Giga)
Vigor2850 Series User's Guide
r 2 8 5 0 V n
r 2 8 5 0 V n
Left LED
(Green)
Right LED
(Green)
Left LED
(Green)
Right LED
(Green)
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On USB device is connected and ready for use.
Blinking The data is transmitting.
On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
On
Wireless access point is ready.
Blinking
It will blink slowly while wireless traffic goes
through.
If ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and it will
return to normal condition after two minutes. (You
need to setup WPS within 2 minutes.)
On The router is ready to access Internet through
ADSL link.
Blinking Slowly: The ADSL connection is ready.
Quickly: The connection is training.
On The router is ready to access Internet through
VDSL link.
Blinking Slowly: The VDSL connection is ready.
Quickly: The connection is training.
On A PSTN phone call comes (in and out). However,
when the phone call is disconnected, the LED will
be off.
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Blinking A phone call comes.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is connected with 10/100Mbps.
6