Controlling The Projector By A Computer - Sharp Conference Series XG-PH80W-N Operation Manual

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to the RS-232C serial terminal on the
computer, or when the LAN terminal on the projector is connected to the LAN terminal on the
computer, the computer can be used to control the projector. Refer to the "SETUP MANUAL"
contained on the supplied CD-ROM for details.
When connecting to a computer using an RS-232C serial control cable
Computer
Note
• When you establish the connection shown above, set "LAN/RS232C" in "Ex. Setting" of the "PRJ-
ADJ" menu to "RS232C".
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
operation manual of the computer for details.
• Refer to "SETUP MANUAL" contained on the supplied CD-ROM for the RS-232C
specifi cations and commands.
Info
• Do not connect the RS-232C cable to a terminal other than the RS-232C terminal on the computer.
This may damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on.
This may damage your computer.
24
To RS-232C terminal
Side view
To RS-232C terminal
RS-232C serial control cable
(cross type, commercially available)