Table of Contents
Advertisement
LAN Unit
Your computer is equipped with a 100 Base-TX/10 Base-T LAN unit. To activate
the LAN unit, perform the following steps.
Use a UTP LAN cable over category 3 if connected to 10 Base-T LAN
unit. If connected to 100 Base-TX, use the cable over category 5.
1.
Turn off the computer.
2.
If your computer is provided with the LAN core, go to the step 4. If with the
core for a shielded LAN cable, go to the next step. If nothing for the LAN unit
is provided, go to the step 4.
3.
Attach the provided core to one end of your shielded LAN cable. Insert the
cable into the slit of the core and put the cable around the core; then, close the
core until it clicks.
4.
If your LAN cable has a core, connect the core end of the LAN cable into the
LAN jack. If not, connect any side of the LAN cable into the LAN jack.
5.
Connect the other end of the LAN cable into the network hub.
Network Hub
6.
Turn on the computer.
7.
In the Network dialog box, set fields according to your network status. Refer to
your network administrator.
LAN Jack
Core(may not be
available in some
countries)
5-5
5
Advertisement
Table of Contents
