Installing Dimms; 16 Dimm Memory Extender Board Layout; Inserting Dimm Into The Extender Board Slot - HP Integrity rx4640 Service Manual

NOTE: One DIMM filler board covers two adjacent DIMM slots. As a general rule, only remove
DIMM slot fillers as you add memory and the correct configuration will always remain.

Installing DIMMs

To install DIMMs, follow these steps:
1. Align the DIMM with the slot located on the memory extender board.
2. Gently and evenly push on each side of the DIMM until it seats in the slot. Ensure that the
extraction levers are in the closed position. Repeat as needed until all additional DIMMs are
installed.
3. Replace the memory extender board. See
4. Replace the front cover. See
5. Replace the front bezel. See
6. If rack mounted, slide the server into the rack until it stops. See
the Rack" (page
Figure 4-8 Inserting DIMM Into the Extender Board Slot

16 DIMM Memory Extender Board Layout

The following details the slot locations, quads, and slot filler requirements on the 16 DIMM
memory extender board.
Figure 4-9 shows the slot locations on the 16 DIMM extender board.
40 Removing and Replacing Components
"Replacing the Front Cover" (page
"Replacing the Front Bezel" (page
32).
"Replacing the Memory Extender Board" (page
35).
34).
"Inserting the Server into
38).