Configuration File Access Errors (Hafoerr - 200 - HP e3000 MPE/iX Manual

Appendix - B
25 MESSAGE: The path format for this Ldev is not correct — (HAFOERR
25)
CAUSE: The path format for this Ldev is not correct.
ACTION: Check for too many periods or missing periods in path specification.
26 MESSAGE: No devices are configured for HAFO — (HAFOERR 26)
CAUSE: No devices have been configured for HAFO.
ACTION: Verify changes made to HAFO configuration have been made
permanent then try again.
27 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 27)
CAUSE: Primary path is already configured.
ACTION: None.
Configuration File Access Errors (HAFOERR —
200...207)
200 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 200)
CAUSE: The HAFOCONF file in the specified configuration group exists but
cannot be opened because of insufficient capabilities or improper access
privileges.
ACTION: Make sure the group you're executing from has PM capability and the
user has SM capability.
201 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 201)
CAUSE: Either the user is not logged on to the SYS account, or the HAFOCONF
file does not exist.
ACTION: Make sure you are logged onto the SYS account, or restore the
HAFOCONF file from a backup. (A new (empty) HAFOCONF file can be
generated by exiting SYSGEN and then running SYSGEN again.))
202 MESSAGE: File close error on < file name > — (HAFOERR 202)
CAUSE: The file system was unable to close the specified file.
ACTION: Call your HP Support Representative for assistance.
54