Alarm Led Lamp Is On - Fujitsu IP-900E Hardware User's Manual

Hide thumbs Also See for IP-900E:

Hardware user's manual (116 pages)

Table Of Contents

100

101

102

103

104

Table of Contents

5.2

This section describes corrective actions to take if an alarm LED turns on.

The appropriate corrective action depends on the alarm code displayed. See the table below for this

information.

See Section 3.3.2, "Log," for information how to check the alarm log check and an

Reference

example with displayed information.

Code

Lxxx

Check the network and destination device. If an error cannot be identified, contact your

system administrator.

Exxx

Turn off and on the device. If the device is still operating abnormally after being powered on

again, contact your maintenance personnel. Then, he/she may ask the alarm code.

Ixxx

This indicates a loss of video input. Check the video output device and video cable connected

to the video input terminal.

xxx: Indicates a three-digit numeric value. See Section 3.3.2, "Log," for more details.

In addition, LED display details are given in the following table:

Display

PWR

Lights in green when the device is powered on.

Blinks in green in the operation preparation state, and lights in green in the operation state.

RDY

Blinks in orange in the maintenance mode waiting state, and lights in orange in maintenance

mode.

No LED lights in normal state. Lights in orange in the state of audio/video input down or

abnormal.

INDWN

Blinks in orange when the input signal slipping for encoder and the reference clock input down

for decoder.

Alarm LED. Blinks or lights in orange when a device alarm occurs.

ALM

For more details of the alarm log, see Section 3.2.2, "Log" and Section 3.2.7, "Log" of

IP-900E/IP-900D series Software User's Guide."

OPT

Lights in green when the HD upgrade option is installed.

Goes on in green during decoding. This LED stays off when decoding is not being

DEC

performed. It blinks in green when a decoding error occurs.

100M

Turns on if the connected LAN is 100BASE.

Indicates the LAN connection status and data send status.

LINK/ACT

It is lit when there is a LAN (HUB) connection, and off when there is no LAN connection.

It blinks when communication is in progress.