Table of Contents
Advertisement
,lemovable Storage Drawer
The storage &awer is a good place to store cookware
and bakeware.
Do not store plastics
and
flammable
material
in the
drawer.
CAUTION:
For your safety, plastics
and
flammable
material must not be kept in this
drawer.
Do not overload the storage drawer. If the drawer is
too heavy, it may slip off' the track when opened. To
open the &awer, grasp the center of the handle and
pull straight out.
The storage drawer may be removed
for cleaning
under the rauge.
To remove:
oPul I the &awer straight out and ] ift over the
guide stops.
To replace:
• Lift over the guide stops and s] ide the drawer
into place.
To clean the inside:
•Wipe with soap and water. Rinse well.
Do not use cleaning powders or harsh abrasives which
may scratch the sur_hce.
To clean the outside:
• Wash with soap and water. Rinse
well.
Do not use cleausing powders
or harsh abrasives
which may scratch the surface.
j
Guide Stop
Control Panel and Knobs
t's a good idea Io wipe the control panel after each
use of Ihe oven. Cleau with mild soap aud water or
vinegar and water, rinse with clean water and polish
dry with a soft cloth.
Do not use abrasive cleansers,
strong liquid
cleansers,
plastic scouring
pads or oven cleansers
on the control panel--they
will damage the finish.
A 50/50 solution of vinegar
and hot water solution
works well.
The control knobs may be removed
for easier
cleaning.
Before removing
the kuobs for cleauing, please note
that the kuobs are in the proper OFF position. When
replacing
the kuobs, check the OFF position to insure
proper placement.
The knob stem has a groove in each side. The groove
on one side has a spring clip. The other groove is
clear (see illustration).
When removing
the knob, it
may be helpflfl to slip a piece of string under and
around the kuob edge and pull up. Check the inside of
the knob and find the molded rib.
Wash the knobs in soap and water or a vinegar and
hot water solmion bm do not soak.
Replace the knob by fitting the molded rib inside the
knob into the clear groove on the stem.
Molde,_
ClearGroove
in Stem
Glass Surfaces
) clean the outside
glass finish, use a glass cleaner. Rinse and polish with
,t &T cloth. Do not allow the water or cleaner to run down inside the
openings in the top of the oven door or the openings in the glass while
cleaning
31
!
llll
Advertisement
Table of Contents
