How To Delay Start Of Cleaning; How To Stop A Clean Cycle - GE JHP56 Use And Care Manual

Hi-low cooking center
Hide thumbs Also See for JHP56:
Table of Contents

Advertisement

,low to Delay Start of Cleaning
Follow the directions
in the Before a Clean Cycle section and then follow
steps I and 2 of How to Set the Oven for Cleaning.
Then push in and
turn the Start Dial to the time you wish to start. Add the hours needed
fl_r cleaning to this start time, then push in and turn the Stop Dial to
this desired stop time. The oven will automatically
turn on aim off at
the set times.
How to Stop a Clean Cycle
Turn the OVEN SET knob to OFF. When the oven has cooled below the
locking temperature,
you will be able to slide the latch handle to the left and
open the door.
Questions
and Answers
Q. Why won't my oven clean immediately
even
though I set all the time and clean knobs
correctly?
A. Check to be sure the Start Dial is set to the same
time as the cooking center clock. Also check to be
sure latch handle is moved to the right.
_, Can I use commercial
oven cleaners on any part
of my self-cleaning
oven?
A. No cleaners or coatings should be used around any
part of this oven. If you do use them and do not
thoroughly
rinse the oven with water, wiping it
absolutely
clean aftel_,ards,
the residue can seal
the oven surface aim dainage metal parts the next
time the oven is automatically
cleaned.
Q. What should I do if excessive
smoking
occurs
during cleaning?
A. This is caused by excessive soil, and you should
turn the oven off. Open windows to rid the room of
smoke. Allow the oven to cool for at least one hour
before opening the door. Wipe up the excess soil
aim reset the clean cycle.
Q. Is the "crackling"
and "popping"
sound I hear
during cleaning normal?
A. Yes. This is the metal heating and cooling during
both the cooking and cleaning functions.
Q. Should there be any odor during the cleaning?
A. Yes, there will be a slight odor during the first few
cleanings.
Failure to wipe out excessive soil might
also cause an odor when cleaning.
Q. What causes the hair-like
lines on the enameled
surface of my oven?
A. This is a normal condition, resulting
from heating
and cooling during cleaning. They do not affect
how your oven performs.
Q. Why do I have ash left in my oven after
cleaning?
A. Some types of soil will leave a deposit, which
is ash. It can be removed with a damp sponge
or cloth.
Q. My oven shelves do not slide easily. What is
the matter?
A. After
many
cleanings,
the oven
shelves
will lose
their luster
and become
hard
to slide. To make the
shelves
slide more
easily, wipe
the shelf supports
with
cooking
oil.
Q. My oven
shelves
have
become
gray
after
the
self-cleaning
cycle.
Is this normal?
A. Yes. After
the self-cleaning
cycle, the shelves
will
lose some luster
and discolor
to a deep gray.
Q:Can
I cook
food on the cooktop
while
the oven
is self-cleaning?
A. Yes. While
the oven
is self-cleaning,
you can use
the cooktop
just as you normally
do.
Q. If my oven
clock
is not set to the correct
time of
day,
can I still self-clean
my oven'?
A. If the clock is not set to the correct
time of day you
will not be able to set a delay-clean
to end at a
specific
time.
25

Advertisement

Table of Contents
loading

Table of Contents