Table of Contents
Advertisement
Dust Collection
DO NOT operate the Model G0739 without an
adequate dust collection system. This sand-
er creates substantial amounts of wood dust
while operating. failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CfM at Dust Port: 100 CfM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1.
Fit a 1
⁄
" dust hose over the dust port shown
1
2
in figure 8 and secure in place with a hose
clamp.
2.
tug the hose to ensure it does not come
off. A tight fit is necessary for proper perfor-
mance.
1
⁄
" dust port
1
2
figure 8. dust port location.
-14-
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting Power
1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
figure 9. Connect power.
Disconnecting Power
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
figure 10. Disconnect power.
Model g0739 (Mfg. since 2/12)
Advertisement
Table of Contents
