Installing Or Removing Battery Cartridge; Charging - Makita 6093D Instruction Manual

Installing or removing battery cartridge
*Always switch off the
tool
before insertion or removal of the battery cartridge.
.To remove the battery cartridge, pull out
the set plate on t h e tool and grasp both
sides of the cartridge while withdrawing it
from the barrel.
0
To insert the battery cartridge, align t h e
tongue on t h e battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the tool.
0
Do
not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so that
the plus and minus terminals on t h e bat-
tery cartridge are on the same sides as their
respective markings on t h e fast charger.
Insert t h e cartridge fully into the port
so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come o n and charging will begin.
If the charging light does not come on,
press the reset button (yellow) first, then
the start button (red). If t h e charging light
goes out within
10
seconds even after pressing the reset button and start button a couple
of times, the battery cartridge is dead. (CAUTION: Wait for more than 5 seconds after
the charging light goes out to press t h e reset button again.) Replace it with a new one.
When t h e charging light goes o u t after about one hour, you may remove the fully charged
battery cartridge.
After charging, unplug the charger from the power source.
CAUTION :
0Your new battery cartridge is not charged. You will need
to
charge it before use.
.Do not keep the button pressed in with tape, etc. o r the circuit will not function pro-
perly. Also, a malfunction of the charger may result possibly causing overheating, etc.
0
If you try
to
charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge cool
off for a while. Then re-insert it
and try to charge it once more.
6