Advertisement
2.
Remove the retaining clip from the brush
shaft, then remove the spacers (Figure 24).
Ratchet Gear
Retaining Clip
Ratchet Gear
Figure 24. Ratchet gear assembly.
3.
Remove the ratchet gear, the spacers on
either side of the ratchet gear, and the ratchet
pin (Figure 25).
Ratchet Gear
Ratchet Pin
Figure 25. Ratchet gear assembly.
4.
Thoroughly clean, then grease the parts
using multi-purpose grease. Re-assemble in
the reverse order from disassembly.
5.
Repeat for the other wheel.
-8-
Brush Shaft
Spacers
Brush Shaft
With extensive use, the brushes on the Model
T10043 may become worn and require replace-
ment.
To replace the brushes:
1.
Tilt the sweeper all the way forward to allow
easy access to the brushes. For the sake of
simplicity, only replace one brush at a time.
2.
Remove the lock nuts and hex bolts indicated
in Figure 26, and remove the old brushes.
It is not necessary to remove the bolts and
nuts connecting the brush holder to the brush
shaft.
Rotation
Overlap Bristles
Brush
Rotation
Figure 26. Brush assembly (end view).
3.
Install the new brush, making sure the over-
lap bristles are properly oriented in relation-
ship to the direction of brush rotation, as
shown in Figure 26. Tighten the hex nuts.
T10043 38" Lawn Sweeper
Brush
Remove
Advertisement
