Table of Contents
Advertisement
Method2
The dryer must be connected
to the cold water faucet using the new inlet hoses. Do not use old
hoses.
t.
If "Y" connector
cannot
be attached
directly to the cold
water faucet,
the short hose must be used.
2. Turn the cold water faucet off.
3. Attach
short inlet hose to cold water faucet.
Screw on coupling
by hand until it is seated on the faucet.
4.
Using pliers, tighten the coupling
with an additional
two-
thirds turn.
[_Do
not overtighten,
as it may damage
the coupling.
5. Attach
'Y" connector
to brass male end of small hose.
Screw on coupling
by hand until it is seated on connector.
6.
Using pliers, tighten the coupling
with an additional
two-
thirds turn.
[_Do
overtighten,
as
may damage
coupling.
not
it
the
7. Attach
angled end of long hoses to the fill valve at the
bottom
of the dryer rear frame. Screw
on coupling
by hand
until it is seated
on fill valve connector.
8.
Using pliers, tighten the coupling
with an additional
two-
thirds turn.
[_Do
not overtighten,
as
may damage
coupling.
it
the
9.
Check that the water faucets
are on.
t0. Check for leaks around
"Y" connector,
faucets
and hoses.
DV331AE-0302dA-01
EN.indd
Sec5:17
installing your dryer
17
2011-03-28
12:18:01
I
Hide quick links:
Advertisement
Table of Contents
