Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
25.8
Action
"Menu"
Scroll to menu H2.
"↵ "
Scroll to menu B8.
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Disable / re-enable alarm devices (H2/B8)
46
Outputs
programmed as type alarm device (sounder) can be disabled
all at the same time. Disabled alarm devices means that even if the
control expression (trigger condition) for the output respectively is
fulfilled (true), the output will not be activated.
The outputs in one or more control units can be disabled or the outputs
in all control units.
Disabled alarm devices are indicated by LEDs Fault / Disablements
"Alarm devices" (L11) and "General disablements" (L10) and shown
in menu H4/U1 from which it is possible to get a print-out.
When all outputs have been re-enabled, The LEDs
"Alarm devices" (L11) and "General disablements"
Disablements
(L10) will be turned OFF, if there are no other disablements in the
system.
The outputs will be disabled until re-enabled again (via this menu).
NOTE! This function may / may not be the same as push button
"Silence alarm devices" (P2), see chapter ""Silence Alarm devices"",
page 28.
Text in display
H2 Disable or re-enable
B1 Disable zone
B2 Disable zone / address
B3 Disable output
B4 Re-enable zone
B5 Re-enable zone / address
B6 Re-enable output
B7 Disable / re-enable output type
B8 Disable / re-enable alarm devices
B9 Disable / re-enable routing equipment
B10 De-activate alert annunciation function
B8 Disable/re-enable alarm devices
100
Fault /
Comments
According to chapter
"Access", see page 85.
Advertisement
Table of Contents
