Recording; Recordinga Tapeon Deckb - JVC MX-GT90 Instructions Manual

Recordi
Continued I_
IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, the SUBWOOFER LEVEL,
and the SOUND MODE controls. Thus, during recording
you can adjust the sound you are aclually listening to
without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. increase the distance
between the TV and the unit.
• You can use lype I tape for recording.
Toprotectyour recording
Cassettes have two small
tabs on the back to protect
from unexpected erasure or
re-recording.
To prolect your recording,
remove these tabs.
To re-record on a protected tape, co_er the holes with
adhesi_ e tape,
Tokeep the best recordingand playbacksoundquality
if the heads, capstans, and pinch rollers of the cassetle decks
become dirty, the following will occur:
• impaired sound quality
• Discontinuous sound
• Fading
• incomplete erasure
• Difficully in recording
*lb clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
Pinch rollers
Capstans
Heads
*lb demagnetize the heads
Turn off the unit, and use a head demagnetizer (ax ailable at
electronics and audio shops).
Recordinga Tapeon DeckB
1
Press EJECT
A tbr the deck B.
2
3
4
5
6
Put a recordable cassette into deck B.
Close the cassette holder gently.
Check the tape direction of deck B.
• If the tape direction is not correct, press TAPE 4 D.-
twice then • to change the tape direction.
Start playing the source -- FM, AM, CD
player, deck A, or auxiliary equipment
connected to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording (see page 19) and Aulo Edit Recording (see
page 20).
• When the source is deck A, you can also use the
dubbing method (see "Dubbing Tapes" on page 19).
Start recording.
,,_,T,_-
/IDTCP
On the unit:
Press REC START/STOP.
On the remote control:
Press and hold REC START/STOP ,_m,,
tbr more than 1 second.
The _ (recording) indicator lights up on
the display and recording starts,
• If no cassette is inserted, "NO TAPE" appears on the
display, If a protected tape is inserted, "NO REC"
appears on the display.
To stop recording immediately, press •,
To remove the cassette, press EJECT A for deck B,
-18-