Common Operations; Turningonor Offthe Power; Selting The Clock; Selecling The Sources - JVC MX-GT90 Instructions Manual

Common Operations
TurningOnor Offthe Power
lb turn on the unit, press
STANDBY/ON O11 so that the
STANDBY lamp goes off,
| IF1
i:= t_ F_El
'lb turn off the unit (on standby), press sr_,_By/o_
STANDBY/ON O/I again so that the #O/_sr_o, ,
STANDBY lamp tights u p
F I-I 11-i"rt ,, 1Z11_lU,__ _ E
A little powerisalwaysconsumed even whiletheunitis on
standby.
'lb switch off the power supply completely, unplug the AC
power cord from the AC outlet,
When you unplug the AC power cord or if a power
hilure occurs
The clock is reset to "AM 12:00" right away, while the tuner preset
stations (see page 12) will be erased in a few days,
Settingthe Clock
Before operating the unit any further, first set the clock built
in this unit,
You can set the clock whether the unit is on or off,
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour
digits start
flashing on the
display,
2 Turn I_,_1 / _-_1 to adjust
the hour, then press
SET/DISPLAY.
The minute digits start flashing on the
display.
%
I_-I'.,I[_U_IRJI y
3
Turn I_1_1/ _-_1 to adjust the minute, then
press SET/DISPLAY.
I Ft t-
Tocheckthe clocktime
Press and hold SET/DISPLAY while playing any source.
• Each time you press and hold the button, the source
indication and the clock time allernate on the display,
Toadjustthe clockagain
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected,
• Each time you press the button, the clock/timer setting
modes change as follows:
C DALLY-- ON TIME "_-RECq
Cance ed_ ON T ME_
(The hour digits start flashing )
/_When you unplug power or a power
the AC cord if
_,L_ failure occurs
The clock loses the setting and is reset to "AM 12:00.' Yot need to
set the clock again.
Selectingthe Sources
'lb listen to the FM/AM broadcasts, press FM/AM. (See
page 12.)
'lb play back CDs, press CD _-/ll. (See pages 13 16.)
'lb play back tapes, press TAPE 4 _. (See page 17.)
'lb select the external equipment as the source, press AUX.
When you press the play button for a particular source
(FM/AM, CD _-/ll, TAPE _1 _, and AUX), the unit turns on
(and the unit starts playing the source if it is ready
COMPU PLAY CONTROL),
if you want to correct the
hour after pressing
SET/DISPLAY, press
CANCEL/DEMO. The hour
digits start flashing again.
_About the audio Level indicator
All the audio level indicators light up when no signals come in.
-9-