Playingbacktapes; Playingbacka Tape; Locating The Beginning Of A Song Music Scan - JVC MX-GT90 Instructions Manual

PlayingBackTapes
You can play back type I, type II, and type IV tapes without
changing any settings.
PlayingBacka Tape
1 Press EJECT (A) tbr the deck you want to
use.
For Deck B
For Deck A
2 Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder
gently.
If you put casseltes in both decks A and B, the last deck
you have put a cassetle into is selecled.
To select the other deck, press TAPE A/B
4
Press TAPE -q _.
The tape play starts and the tape
direction indicator (_ or 4) starts
flashing slowly to indicate the tape
running direction.
• Each lime you press the bulton, the
tape direction changes.
I_ : plays the front side.
_1 : plays the reverse side,
• if no cassetle is inserted, "'NO TAPE" appears on the
display.
When the tape plays io the end, the deck automatically
stops if the Reverse Mode is not on, (See '"To play both
sides repeatedly Reverse Mode,")
'lb stop playing, press 1L ,,_
'Ib operate the other deck, press TAPE A/B,
then TAPE 4 _,
'lb fast-wind to the left or to the right, press _ or
(1414 or _ on the remote control) while the tape is not
running.
The tape direction indicator (4 or D,-) starts flashing quickly
on the display,
'lb remove the cassette, press A EJECT for deck A or
EJECT _ for deck B,
Toplay bothsides repeatedly-- ReverseMode
Reverse Mode works for both decks at the same time,
When it is in use, the tape automatically reverses at the end of
a side and the unit starts playing for the other side of the tape,
and repeats the same process,
'lo use Reverse Mode, press
REVERSE MODE so that the Reverse Mode
indicator on the display lights up like (. _ ).
'1o cancel Reverse Mode, press the button
again so that the Reverse Mode indicator on the
display lights up like _.
When Reverse Mode is on with cassettes in both decks
A and B
After the reverse (_1) side of the tape finishes playing, the tape in the
other deck starts playing.
Locatingthe Beginningof a Song
-- MusicScan
YOUcan use Music Scan to locate the beginning of a song,
Music Scan searches for blank portions that usually separate
recorded songs, then plays the next song.
Tofindthe beginningof the currentsong
During play, press _ or _ (141-qlor
on the remote control) in the opposite
direction Io the tape play,
The tape direction indicator of the opposite
direction to the tape play starts flashing
slowly,
Searching stops automatically at the beginning of the current
song, and the current song starts aulomatically.
Tofindthe beginningof the next song
During play, press _ or _ (141-qlor
on the remote control) in the same
direction as the tape play.
The tape direction indicator of the same
direction as the tape play starts flashing
slowly and quickly alternately.
Searching stops automatically at the beginning of the next
song, and the next song starts aulomatically.
Music Scan works by detecting a 4-second long blank
between each song, so it will not work well in the
tbllowing cases
• No blank at the beginning of a song.
• Noise (often caused by much use or poor quality dubbing) which
fills the blank.
• Long, very soft passages or pauses in a song.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
-17-