Plug In The Refrigerator - GE 20 Owner's Manual & Installation Instructions

Side by side refrigerators
Table of Contents

Advertisement

Available languages

Available languages

Installation instructions
m
I
Im CONNECT THETUBINGTOTHE
REFRIGERATOR (CONT.)
Some models have the refrigerator
connection at the
end of tubing located outside the compressor
compartment
access cover. On other models, the
compressor compartment
access cover must be removed
in order to access the refrigerator
connection at the
water valve.
%
On models using the refrigeration
connection
at the
water valve, remove the plastic flexible cap.
©
Place the compression nut and ferrule (sleeve) onto the
end of the tubing as shown. On a GE SmartConnect TM
Refrigerator
Tubing kit, the nuts
are already assembled to the tubing.
Insert the end of the tubing into the refrigerator
connection
as far as possible. While holding the tubing,
tighten the fitting.
For plastic tubing from a GE SmartConnect 'M
Refrigerator
Tubing kit, insert the molded end of the
tubing into the refrigerator
connection and tighten the
compression
nut until it is hand tight, then tighten one
additional turn with a wrench. Overtightening
may
cause leaks.
Fasten the tubing into the clamp provided as shown to
keep it in position. You may need to pry open the
clamp.
One
of
the
illustrations
below
will
look
like
the
connection
on
your
refrigerator.
Tubing
Clamp
1/4"
Compression
Nut
1/4"
Tubing
Ferrule
(sleeve)
Refrigerator
SmartConnectTM
Connection
Tubing
[-_ CONNECT THETUBINGTOTHE
REFRIGERATOR (CONT.)
Tubing
I14"
Clamp
¢_mpmssion
Rut
1/4"
Tubing
Ferrule
(sleeve)
Refrigerator
Connection
SmaltOonnect TM
Tubing
[]TURN THEWATERONAT THESHUTOFF
VALVE
Tighten any connections that leak.
Reattach the access cover.
[_] PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator
or against the wall.
Push the refrigerator
back to the wall.
Ff0-]
STARTTHEiCEMAKER
Slide the icemaker power switch to the 0/V position. The
icemaker will not begin to operate until it reaches its
operating temperature
of 15°F (-9°C) or below. It will
then begin operation
automatically
if the icemaker
power switch is in the 0/Vposition.
O
ON -OFF
I ,
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

2225

Table of Contents