Advertisement
Installation
Instructions
Cooktop Burners
cont.
Checking the Igniters
Operation
of the electric
igniters should
be checked
after the cooktop
and supply
line have been carefully
checked
for leaks
and the cooktop
has been connected
to
the electrical
power.
a. Push and turn a burner valve to the LITE
position.
• The burner valve should light when gas
is available
to the burner
• Once the burner lights, it should be
turned out of the LITE position.
b. Try each valve separately
until all burners
have been checked.
Burner Ignition
Cooktop Spark Ignition--When
you turn the
cooktop knob to LITE, the spark igniter
makes a series of electric sparks (ticking
sounds) which light the burner.
During a power failure, the burners will not
light automatically.
In an emergency, a
cooktop burner may be lit with a match by
following
the steps below.
I
WARNING:
Lighting gas burners with a
match is dangerous.
You should match
light the cooktop burners only in an
emergency.
a. Light a match and hold the flame near the
burner you want to light. Wooden matches
work best.
b. Push in and turn the control knob slowly.
Be sure you are turning the correct knob
for the burner you are lighting.
NOTE: If the burner does not light within five
seconds, turn the knob off and wait one minute
before trying again.
The Burner Flames
Turn each burner on. Flames should be blue
in color with no trace of yellow. The burner
flames
should not flutter or blow away from
the burner. The inner cone of the flame
should be between
1/2" and 3/4" long.
Cooktop
Burner
Burners should be checked frequently
I
ARNING:
If you attempt to measure
I
the inner cone of the flame, please use
caution,
Burns could result,
25
Advertisement
