Specifications; Safety Instructions - Craftsman 351.183230 Owner's Manual

DESCRIPTION
The Sears Craftsman 18 Gauge BradNailer drives b rads l'rom
V."to 2" long, Die cast aluminum textured finish body reduces
operator fatique. Large capacity, side loading magazine with
positive, quick action latch makes loading easy. Contact safe-
ty disables nailer unless nosepiece is in contact with work-
piece. Tapered nosepiece provides operator with greater visi-
bility for precise brad placement. Rigid nosepiece reduces
jamming. The gears 18 Gauge Brad Nailer is excellent for
molding and decorative trim, furniture making and picture
framing.
SAFETY INSTRUCTIONS
• Air tool operators and all others in work area should always
wear safety goggles (must comply with ANSI Z87.1) to
prevent eye injury from fasteners and flying debris when
loading, Ol_rating or unloading this tool.
• Never exceed operating pressure of 100 PSI (7,1 kg/em').
• Always keep hands and body away from the fastener dis-
charge area when air supply is connected to tool.
• Always disconnect tool from air supply when servicing or
adjusting tool end when tool is not in use,
• Do not operate tool when nose is not in contact with work.
• Never load the tool until you are ready to use it.
• Never depress tool trigger when loading.
• Always load tool with nose pointing away from you and
others.
• Never point tool at yourself or others,
• Never carry tool with trigger depressed.
• Do not use oxygen, combustible gas or high pressure com-
pressed gas as the air supply for the tool.
• Always use tool at safe distance from other people in work
area.,
• Do not attempt to discharge tkstener into hard or brittle
materials such as concrete, steel or tile.
• Do not connect female quick-disconnect ctmpiing to tool
side of air line.
• Connect male, free-flow nipple to tool side of air line so
that tool is depressurized when diSconnected from hose,
• Do not use a hose swivel with this tool.
• Use Sears recommended fasteners only.
SPECIFICATIONS
Capacity ............................. 100 brad nails
Brad nail size .................. 18 gauge (.049 x .040")
Brad nail Icnglhs ............................ ¼ to 2"
Operating pressure ....................... 60-100 PSI
Air inlet ............................... V," F.N.P.T.
Length ...................................... 9'/,"
lleight ...................................... 9'/,."
Width ....................................... 2_,_"
Weight ................................... 3.5 Ibs.
Brad Nails
_] 8341 ................... 18 gauge brad nails, V," hn_g
_18342 ................... 18 gauge brad nails, l" long
t] 8343 .................. 18 gauge brad nails, 1'A"long
918360 .................. ] 8 gauge brad nails. 1'/_"long
918361 .................. 18 gauge brad nails, 1)/," hmg
t18362 .................... 18 gauge brad nails 2" long
OPE" RATING INSTRUCTIONS
Air Supply Line
Refer to Figure 1.
• The Sears brad nailer operates on compressed air at pres-
sures fi'om 60 to 100 PSI.
• Never exceed maximulla pressure.
Minimum air requirements for nailer: Average working
SCFM 3.2 at 90 Pal.
WARNING; KEEP HANDS AND BODY AWAY FROM
DISCHARGE AREA OF TOOL WlIEN
CONNECTING AIR SUPPLY. ALWAYS
DISCONNECT TOOL FROM AIR SUPPLY
WHEN SERVICING OR ADJUSTING
TOOL AND WHEN TOOL IS Nor IN USE.
-.. a
Figure 1-Air _upply Line
2