GE AGF05 Owner's Manual And Installation Instructions page 5

Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
GEAppliances.com
COOLMode
Use the COOL Inode with HIGH(F3),MED (F2)or
LOW(F1)tim for cooling. Use the INCREASEA/
DECREASEVpads
to set the desired temperature
between 60°F and 86°F in l °F increments.
An electronic themtostat is used to maintain the
room temperature. The compressor will (-)'de on and
off to kee I) the room at the set level ot comfi)rt. Set
the them(ostat at a lower number and the indoor air
will become (()()let: Set the them/ostat at a higher
number and the indoor air will become war)net;
NOTE." ff the ak conditioner is off and is then tumed on
while set to COOL, it will take approximately3 minutes
for the compressorto start and cooling to begin.
Cooling Descriptions
ForNormalCoolino---Select the COOL m(>de and
HIGH(F3)or IVIED (F2)lim with a middle
set
temperature.
ForMaximum
Cooling---Select
the COOL mode
and HIGH(F3)tilt(with a lower set temperatm'e.
ForQuieter& NighttimeCoolino---Select the
COOL m(>de and LOW (FI)tilt( with a middle
set
temperamre,
NOTE:If you switch from a COOL setting to OFFor to
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
FAN Mode
Use the FANat HIGH(F3), M ED (F2)or LOW(F1)to
provide air circulation and filtering without cooling.
Since lilt( only settings do not provide cooling,
a temperature setting will not be displayed.
Additional controls and important information.
Air Direction
Fingertip pressure on the lou\'et_ lets you control
the air direction lelL right, straight ahead or any
combination of these directions.
5