GE AGF05 Owner's Manual And Installation Instructions page 4

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
MP • Energy
_ Saverorl
- Fanon
- Timer on
Air ConditionerControls
Remote Control
Controls
O ON/OFFPad
Turns air conditioner on and off.
Display
Shows the set teml)erature .... or time remaining,
@
o
@
@
on tililei:
MODE
Use to set the air conditioner to COOL or
FAN m ode.
Increase •/Decrease • Pads
Use to set temperature when in COOLmode.
FAN Pad
Use to set the tim speed to LOW(FI), MED (F2)
or HIGH (F3).
ENERGYSAVER
(on some models)--Controls
the tim.
ON--The tim and compressor cycle on and
off. This results in Mder \m_iations of room
temperature and humidim Nom_allv used
when the room is tmoccupied. NOTE"Thefan
will continue to run for a short time after the
compressor cycles off
@
@
OFF--The tim runs all the time, while the
COlIlpI'eSSOI"
cycles
on _111(1 ()]c{,
This teatm'e must be set at OFFin order to
use the tim settings (on the mode control).
TIMER Pad
ON--X_'hen the air conditioner is off, it can be
set to automatically come on in 1 to 12 hom_
at its previous setting. Each touch will set the
timer in hom_.
OFF--_q_ei,_ the air conditioner is on, it can
be set to automatically, turn off in 1 u) 1_2
hom_. Each touch will set the timer in hom_.
Tocancel the timer, press the TIMER pad
tmdl the displa) time disappears.
Remote Control Signal Receiver
4
Remote Control
!i_:To ensm'e proper operation, aim the remote
control at the signal receixer on the air
conditione_:
!i?:The remote control signal has a range of
11 I) to 21 tb'et.
_: Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
_: Make sure batteries are fl'esh and installed
correctly as indicated on the remote control.