Advertisement
KNOW
HOW TO USE TOOL
•
Use right tool for job. Do not force
tool or attachment to do a job for
which it was not designed.
•
Do not force tool. It wilt work most
efficiently at the rate for which it was
designed.
•
Keep hands away from moving parts
and cutting surfaces.
•
Know your toot. Learn the tool's
operation, application and specific
limitations.
•
Use of improper accessories may
cause risk of injury to persons.
•
Handle workpiece correctly. Protect
hands from possible injury.
•
Turn machine off if it jams. Chisel or
bit jams when it digs too deeply into
workpiece. (Motor force keeps it
stuck in the work.)
CAUTION:
Think safety! Safety is a
combination of operator common sense
and alertness at all times when tool is
being used.
Refer to Figure 1.
•
Insert thumb screw (Key No. 6) into
housing (Key No. 1).
•
Insert rod (Key No. 9) into fence
(Key No. 10) and secure in position
with thumb screw.
•
Mount clamp (Key No. 7) onto rod
and secure in position with thumb
screw.
•
Insert curved rods (Key No. 11). into
fence and secure in position with
thumb screw.
WARNING:
Disconnect drill press
from power source until all assembly
steps are complete.
Refer to Figures 1 and 2.
•
Lower drill press spindle 2 to 3 inches.
Lock spindle in position.
•
Measure diameter'A'
of quill stop
collar (see Figure 1):
75mm - Slide housing (Key No. 1)
over quill and secure onto quill stop
collar by tightening ratchet handle
(Key. No. 5). Thumb screw (Key. No.
6) should face away from drill press
column.
66mm - Insert 66mm split bushing
(Key No. 2) into housing, then install
housing onto quill. Make sure slot in
bushing is aligned with slot in hous-
ing.
60mm - Insert both 66mm and
60mm split bushings (Key No. 2) into
housing, then install housing onto
quill.
3
-
B
1
Quill Stop Collar
Figure 1 - Measuring Quill; Locating
Two-piece Bushings
•
For other quill stop collar sizes, the
two-piece bushings (Key No. 3) are
used. Measure diameter of quill 'B'.
This kit includes three sets of
two-piece bushings to fit quill diame-
ters of 40, 48 and 50mm. Slide rub-
ber bumper towards top of quill.
(When quill is retracted, bumper will
rest on top of bushings.) Select the
appropriate two-piece bushing set
and place on top of quill stop collar
(See Figure 1).
Advertisement
