Messages And Signals - Sharp FO-5600 Operation Manual

DD <P=001>
Display messages
CHECK XXXX (paper source)
CONF REFUSED
CONF. RX ERROR
COVER OPEN
DRUM LIFE OVER
FAX RCVD IN MEMORY
FUNCTION MODE
LINE ERROR
MEMORY FULL
NO CONF. FUNC
NO PAPER
NO RELAY FUNC
USED FOR COMM

MESSAGES AND SIGNALS

A paper source or combination of paper sources will appear in
place of "XXXX". This indicates that the paper source is not
properly installed in the machine, or a paper jam has occurred
in that source. (Note that "UPPER" indicates the upper
cassette and "LOWER" indicates the lower cassette if you
have two cassettes.)
A confidential transmission has been denied because you
entered an incorrect mailbox number for a machine with
mailboxes.
Confidential reception was cancelled because the mailbox
number specified by the transmitting machine is not
programmed in your fax.
The operation panel is open. Close it.
The drum cartridge must be replaced.
A fax has been received in memory because the toner
cartridge needs replacement, you have run out of printing
paper, or the paper is jammed. The fax will automatically print
out when the problem is fixed.
The FUNCTION key has been pressed.
Transmission or reception was not successful. Press STOP to
clear the message, and then try again.
The memory is full. See "Dual access" in "Sending
Documents" in Chapter 3.
Confidential transmission was cancelled because the receiving
machine does not have a confidential function, a confidential
passcode is not programmed in it, its memory is full, or it is not
a Sharp model.
This message will be followed by one or more of the paper
sources in parentheses ("UPPER " indicates the upper
cassette and "LOWER" indicates the lower cassette if you
have two cassettes), and informs you that those paper sources
are out of paper. If no paper source is indicated, all paper
sources are out of paper.
A relay request has been denied because the other machine
does not have a relay broadcast function, its memory is full, or
it is not a Sharp machine.
When trying to delete a Rapid Key which is already used for a
program, group or timer operation.
TROUBLESHOOTING
FO5600A-TSDM
8-3