Dust Collection; Fence Assembly - Grizzly G0513 Owner's Manual

Dust Collection

DO NOT operate this bandsaw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Each Dust Port:
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must take into account
many variables, including the CFM rating of the
dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system. Explaining this calcu-
lation is beyond the scope of this manual. If you
are unsure of your system, consult an expert or
purchase a good dust collection "how-to" book.
To connect a dust collection hose:
1.
Figure 21
2.
Note: A tight fit is necessary for proper
performance.
Figure 21.
3.

Fence Assembly

To assemble the fence:
1.
inside of the rear fence rail, remove the rail
end plug to retrieve it.
400
2.
3.
Figure 22.
4.
If a cap screw falls